Share your ideas, questions or suggestions with us here.
5 posts • Page 1 of 1
Just installed GhostBSD 4.0 Alpha, and there was a couple hiccups that I noticed. During the initial install, the installer failed both using the option of using the entire disk, and with the partition editor on a hard drive that previously did not have BSD installed. I ended up using GhostBSD 2.5 to create the partitions in order to install the 4.0 alpha. In addition once installed, my network card was not enabled. I enabled "gre" network module and the corresponding "re0" for my ethernet card in boot/loader.conf and then rebooted the machine in order to get my network up.
I can't find pc-sysinstall log, GBI did not failed, only it can't find hdd. I selected the "use entire disk" option and GBI just show an empty window. This tests was made on virtualbox with default settings at first and with ahci after that. Same results in both cases.