It happens sometimes I need to test/install GhostBSD on some machine that doesn't have a WiFi adapter at all, in this case I connect the GhostBSD machine to my Linux connected machine:
[ Internet ] <-> [ wifi router ] <-> [ Linux ] <- ethernet cable -> [ GhostBSD (or other OS) ]
Note: You can use a straight 1 to 1 cable if both eth devices support autosensing, this is the case for Gigabit capable eth devices, otherwise you need to use a crossed cable when using older non-autosensing eth devices.
How is shared the connection: by using iptables filters.
I'm running Arch, however iptables is widely used in many Linux distros
Code: Select all
# Generated by iptables-save v1.6.0 on Mon May 9 18:10:38 2016 *filter :INPUT ACCEPT [1:118] :FORWARD ACCEPT [0:0] :OUTPUT ACCEPT [2:130] -A FORWARD -m conntrack --ctstate RELATED,ESTABLISHED -j ACCEPT -A FORWARD -i enp7s0 -o wlp6s0 -j ACCEPT COMMIT # Completed on Mon May 9 18:10:38 2016 # Generated by iptables-save v1.6.0 on Mon May 9 18:10:38 2016 *nat :PREROUTING ACCEPT [34:4882] :INPUT ACCEPT [0:0] :OUTPUT ACCEPT [0:0] :POSTROUTING ACCEPT [0:0] -A POSTROUTING -o wlp6s0 -j MASQUERADE COMMIT # Completed on Mon May 9 18:10:38 2016
enp7s0 is the name of my Linux Eth device (usually named eth0)
wlp6s0 is the name of my Linux Wifi device (usually named wlan0)
the wifi network is: 192.168.1.0/24 and the wifi card has an address in that range, say 192.168.1.1
the eth network is: 192.168.2.0/24 and the eth device has an address in that range, say 192.168.2.254
be sure to start the iproute service, command may vary depending on your init system.
That's all on Linux side.
On the GhostBSD machine the INET address must be manually set to something in eth network range, say 192.168.2.1
and set the DEFAULTROUTER to 192.168.2.254 which act as a gateway.
issue the following two commands, and your GhostBSD machine is ready to go:
Also, do do forget to set some DNS, say 188.8.131.52 or 184.108.40.206 (google dns)
Code: Select all
/etc/rc.d/netif restart /etc/rc.d/routing restart