hi ! Many thanks first for the job, i can't wait to test this version of BSD which looks perfect!
I was able to install the latest version, stable 13 without any problem, but I cannot configure my ethernet network ... I followed the tutorial but when I do an ifconfig -a I only have Lo0, nothing other, my bios is however well regulated in UEFI, my card network too.

pq. sorry for my bad english i'm french...

to add some informations of my config, its a intel card on gigabyte z490 mb

OK... Ethernet controller: Intel Corporation Ethernet Controller I225-V doesn't be support by BSD

testing this one https://www.freebsd.org/cgi/man.cgi?que ... ease-ports

doesnt supported
https://www.intel.com/content/www/us/en ... -5gbe.html

If the GhostBSD card does not appear in ifconfig after boot it is most likely not supported.

HI Eric, yes, FreeBSD will integrate this new Intel card in his next RELEASE
take a look https://forums.freebsd.org/threads/inte ... yet.80991/

Since GhostBSD follows stable and not release, it will get in when it gets merged into the 13.0-STABLE repo.

yep, in few weeks or months...

Perhaps Eric you could explain how to implement this driver right now ?
a guy on FreeBSB forum told me : and are willing to build system components from source (kernel or kernel module) you can have the driver right now.
The linked revision comes with a patch which can be applied to the system source to build the igc(4) driver. I've tested the patch, kernel or kernel module alone builds fine on 13.0-RELEASE, but I can't test the functionality, no hardware. Try the kernel module.
the patch is here but how using it ? https://reviews.freebsd.org/file/data/d ... 30668.diff